![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Feb 2013
Location: GA
Posts: 1,313
|
1966 Hood corner patch repair question
Do the sides of the hood slope inward toward the cab? Or should you be able to take a straight edge and it be flush all the way down?
![]() I wish I had placed a straight edge on it before I made any cuts to see if it slopes like this or not originally, but I made a cut ![]() After cleaning out the area inside as best I could and painted 3 coats of epoxy primer, I welded the patch panel in place ![]() Then I looked closer at the edges and saw how the guys at the sandblasters were not careful using their fork lift and dented the hood in some places. On that side I saw this ![]() I did my best to hammer/dolly the dented edge that makes contact with the fender when closed and its back flush and looking ok now. I also hammered the outward dent on the side to the straight edge would line up. I took the fender extension and placed it at the base and it lines up pretty good ![]() So do I need to drill out the spot welds and pull that base edge out some to line up flush? Seems like if I do that the fender extension panel wont line up too well. |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|