A little help please. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

64shortbed · 04-04-2016, 05:05 PM

I've been looking but I am unable to find what may be the cause. my truck is a 64 GMC. I have 1985 c10 A-arms and spindles. After I did the swap i had a alignment done. I did cut 1 1/2 coil of the coils. Drives great does not pull, goes straight. But when i pull into my drive way to park or have to turn sharp the front likes to jump or slide. What could be the cause and how do i check it. Is it negative camber from cutting the coils? My tires where already wore some but they do look like they are running more on the inside then the center?

Please let me know if I'm on the right track. If so then i just need to add shims to the top A-arm right?

04-04-2016, 05:05 PM	#1
64shortbed Registered User Join Date: Feb 2012 Location: Scott city, ks Posts: 301	A little help please. I've been looking but I am unable to find what may be the cause. my truck is a 64 GMC. I have 1985 c10 A-arms and spindles. After I did the swap i had a alignment done. I did cut 1 1/2 coil of the coils. Drives great does not pull, goes straight. But when i pull into my drive way to park or have to turn sharp the front likes to jump or slide. What could be the cause and how do i check it. Is it negative camber from cutting the coils? My tires where already wore some but they do look like they are running more on the inside then the center? Please let me know if I'm on the right track. If so then i just need to add shims to the top A-arm right? __________________ 1964

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.