Just Ordered My Parts - The 1947 - Present Chevrolet & GMC Truck Message Board Network

8t5Silverado · 03-12-2004, 10:19 PM

Well, I have been himming and hawing for a while now about what to do first. If you've seen my truck, you know that there are many places to start.

Anyway, I figure safety should be my first concern...so I got a Ramjet crate motor. (just kidding)

I needed balljoints. So I figured while I have that apart, I had better get my springs and drop spindles. And while I am dropping the front, I had better drop the rear.

It will be a week or so before I get all of the parts. In that time, I will probably talk myself into getting a complete poly bushing set, etc.

03-12-2004, 10:19 PM	#1
8t5Silverado Mudslides 'r my specialty Join Date: Dec 2003 Location: STL Posts: 1,106	Just Ordered My Parts Well, I have been himming and hawing for a while now about what to do first. If you've seen my truck, you know that there are many places to start. Anyway, I figure safety should be my first concern...so I got a Ramjet crate motor. (just kidding) I needed balljoints. So I figured while I have that apart, I had better get my springs and drop spindles. And while I am dropping the front, I had better drop the rear. It will be a week or so before I get all of the parts. In that time, I will probably talk myself into getting a complete poly bushing set, etc. __________________ Always on the lookout for old cars and parts...(20s, 30s, 40s, 50s, 60s, etc.) http://www.cardomain.com/memberpage/500339

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.