Problems with new 700r4 TV Cable - The 1947 - Present Chevrolet & GMC Truck Message Board Network

BigRed · 03-16-2004, 11:45 PM

I just put a GM TV cable on my 700r4 because the O'Reilly one I bought was not keeping it's setting.

Anyway, I got this new one on and I'm trying to adjust it but something is not right. I have tried to adjust it and still can't get the thing to shift. I get up to about 25mph and let off because I don't want to jack up the RPMs too much. I know the cable is attached to the tranny because I've checked that twice. I've followed the instructions here --> http://www.73-87.com/7387garage/drivetrain/tvcable.htm and have tried to bring the shaft towards the firewall and I'm about at the end and still nothing.

Does anyone have a clue what could be causing this?

03-16-2004, 11:45 PM	#1
BigRed Registered User Join Date: Jun 2002 Location: DFW, TX Posts: 1,680	Problems with new 700r4 TV Cable I just put a GM TV cable on my 700r4 because the O'Reilly one I bought was not keeping it's setting. Anyway, I got this new one on and I'm trying to adjust it but something is not right. I have tried to adjust it and still can't get the thing to shift. I get up to about 25mph and let off because I don't want to jack up the RPMs too much. I know the cable is attached to the tranny because I've checked that twice. I've followed the instructions here --> http://www.73-87.com/7387garage/drivetrain/tvcable.htm and have tried to bring the shaft towards the firewall and I'm about at the end and still nothing. Does anyone have a clue what could be causing this? __________________ Scott Shelbourne

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.