![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#11 |
Senior Member
![]() Join Date: May 2007
Location: Doodah Kansas
Posts: 7,773
|
Re: 49 3600, s10 swap, project boogie
fits like it was made to be there. the nice thing about the fullsize box is that everything unloads from the bottom, so instead of guessing where to drill holes for the pass through and trimming the dash to make it fit, I just took the heater core and evaporator out and slipped it up in place.
![]() the glovebox will be short only on one side, and the wipers and vents have no interference. I might even be able to get it up a couple more inches, the inlet for the fresh air is hitting the cowl, if I trim it the unit will go even higher.
__________________
the mass of men live lives of quiet desperation if there is a problem, I can have it. new project WAYNE http://67-72chevytrucks.com/vboard/s...d.php?t=844393 |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|