I Believe this is a Resister ,but it fell apart while

[GOPAPA]

reinstalling the duct work behind the dash...I need assistance in putting it back together the correct way ..

I have these 3 parts and I have used search on this forum and my two books ,,one being the service manual and the other the factory assembly instruction manual .. none of them gives me exactly what I need to put this switch together.

As shown I have 3 parts .. one is the spring that is smaller on one end than the other.,, it fits over the plastic nipple looking part and both fit up into the casing of the switch ..

My question is this ..does this washer go to this assembly and if so ,, where is it located ,, it is a fiber washer and not metalic.

the washer does not fit over the nipple thing



jpg.gif SAM_3299.jpg (29.6 KB) Remove
jpg.gif SAM_3300.jpg (23.4 KB) Remove
jpg.gif SAM_3298.jpg (37.5 KB)