|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-03-2004, 01:02 PM
|
#1 |
|
F.A.S.T. president
 
Join Date: Sep 2003
Location: Florida
Posts: 1,883
|
progress pic and need help
hey everyone, I started to mock up the engine and transmission today. Can someone help me with a measurement? I need to have a few dimmesions if posible from the front lip on the crossmember to the center of the crank or to the pan rail or anything else that will help make shure this engine is at the right height before I start fabricating the trans mission crossmember to the correct angle.
Last edited by jamis; 10-05-2007 at 07:11 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode