The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-20-2017, 02:42 PM   #1
71CHEVYSHORTBED402
Senior Member
 
71CHEVYSHORTBED402's Avatar
 
Join Date: Feb 2009
Location: Northern Nevada
Posts: 7,323
Original coolant expansion tank install

Apparently these were dealer installed. Some factory, which MAY be limited to govt. trucks. I'm guessing they were dealer installed varying on State requirements.

Anyway, I wanted to sample fit one onto my core support. This is my "bad" tank. Pretty sure I have a recipe for that stain. Anyway, below are the instructions. The way I read it the top mounting hole is 8.5/8" higher than the horn hole. Well, I dropped it near 1/2", because I wanted it below the ridge on the core support. Contributed to that, the instructions call for a 3/8" tilt. I don't know, I prefer things upright, though 3/8" isn't that noticeable. The tilt provides added clearance and it's more or less consistent with the slope in the top of the core support. That and you can bend the bracket.

There's not much clearance between the port in the tank and the low horn. Maybe 1.25"........It would work fine as is, though the hose may rest on the horn. I don't want any pressure on that port, and there's a lot of real estate on the LH side, especially without a voltage regulator. So I'm making a 4x4ish" plate as an option, probably aluminum. That will add up to 2" more clearance to the left, and really, more clearance in every direction. Very little of the plate will be visible, if at all.

Not exactly rocket science, but glad to have finally figured it out so I can pull the radiator. Zepplin was real helpful.................BTW, free 4-core radiator un-shipped. It's not truck correct, but it works less the port for a heater hose on a BBC........Doesn't fit the shroud.








__________________
Tony
71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assembly kit for restoring the (a) truck from the ground up. My build thread, and more on the assembly kit https://67-72chevytrucks.com/vboard/...d.php?t=730025
71CHEVYSHORTBED402 is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:57 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com