|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-05-2017, 11:36 AM
|
#1 |
|
Registered User
Join Date: Apr 2015
Location: East Tn (In the heart of the Smoky Mtns)
Posts: 1,893
|
Factory tach +Electronic Conversion Module
My factory tach is reading 200 rpm at idle. I just recently replaced my printed circuit board, and prior to that my tach worked fine.
I do have a Mallory Electronic Conversion Module, in place of points. Again I say, the tach used to work fine. But could the ECM be causing my issue? If it is cause, is there a filter like those used by people running HEI distributors? |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode