'50 chevy 3100 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Matt_50 · 08-31-2017, 08:36 PM

I ran across something I'm a little iffy about. I'm sure I can probably make it work if it is incorrect but I'd like to avoid as much sheet metal alignment problems as possible. When I got the truck the front was partially disassembled and the guy had to hunt some pieces down. One was the radiator support. I did a test fit today of inner fenders because I need to drill new bolt holes in the sheet metal I used to repair a corner.

The radiator support has holes in all the right spots to mount to the inner fenders. It's where it mounts crossmember that looks different than catalog pics. Does this look correct?

08-31-2017, 08:36 PM	#11
Matt_50 Registered User Join Date: Jul 2017 Location: Joshua, Texas. Posts: 1,303	Re: '50 chevy 3100 I ran across something I'm a little iffy about. I'm sure I can probably make it work if it is incorrect but I'd like to avoid as much sheet metal alignment problems as possible. When I got the truck the front was partially disassembled and the guy had to hunt some pieces down. One was the radiator support. I did a test fit today of inner fenders because I need to drill new bolt holes in the sheet metal I used to repair a corner. The radiator support has holes in all the right spots to mount to the inner fenders. It's where it mounts crossmember that looks different than catalog pics. Does this look correct? Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.