|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-09-2017, 04:37 PM
|
#4 |
|
Registered User
Join Date: Apr 2014
Location: Raleigh, NC
Posts: 51
|
Re: Pinion marks disappeared
So, I have a GM handbook, and it shows the steps without mentioning preload, or removing axels to take the pinion nut and torque to 270 lb ft. I am wondering if this is my best bet as now I cannot confirm the proper placement of the nut from original markings. Thoughts?
Additional Note: If the crush sleeve was originally set to the proper spec, I would assume torquing to the original spec would work. |
|
|
| Bookmarks |
| Tags |
| differential, pinion, rear end, seal, torque |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode