Is taillight panel removable? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Praxiss454 · 10-21-2017, 05:45 PM

Howdy folks,

At some point a previous owner backed my truck into something, and banged the crap out of the driver's side rear. I've been able to pull out some of the big crease in the bed side, but can't make any progress on the taillight panel.

There is a slight gap between this panel and the bed side panel, which makes me think it can be removed, possibly even unbolted. A previous owner filled that gap in a few spots with body filler, and as I was digging it out I found about 4 spots where it was welded. If I cut through those welds with my angle grinder, what else do I need to do to pop this sucker off?

10-21-2017, 05:45 PM	#1
Praxiss454 Registered User Join Date: Jun 2016 Location: Novato, CA Posts: 519	Is taillight panel removable? Howdy folks, At some point a previous owner backed my truck into something, and banged the crap out of the driver's side rear. I've been able to pull out some of the big crease in the bed side, but can't make any progress on the taillight panel. There is a slight gap between this panel and the bed side panel, which makes me think it can be removed, possibly even unbolted. A previous owner filled that gap in a few spots with body filler, and as I was digging it out I found about 4 spots where it was welded. If I cut through those welds with my angle grinder, what else do I need to do to pop this sucker off? __________________ 1965 GMC 1000 SWB Fleetside L6 230 - SOLD Thanks everyone for the help over the years.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.