|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-06-2017, 05:02 AM
|
#1 |
|
Registered User
Join Date: Nov 2015
Location: Lebanon, Oregon
Posts: 35
|
Flat out engineering C-4 axle problem
The bracket that mounts the dog bones to the hub assembly cut into my aluminum axle. Went in about 1/2". Everything is tight and mounted properly. Only did it on the drivers side. Got a new axle and replaced all the bushings with polyurethane. There is only 1/4 inch between the bracket and the axle. Could the torque from my big block twist the axle mounts enough to do this or is there some other cause?
__________________
1957 Chevy 3100 402 BBC 700R4 transmission c-4 Flat Out Engineering suspension |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode