|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-21-2018, 11:52 PM
|
#10 |
|
Registered User
Join Date: Dec 2000
Location: Boise, Idaho
Posts: 6,003
|
Re: What did you do with your truck today, Part 3
I got out to the garage and welded a little seam. But then started to make a patch for the top of the cowl at the windshield that is rusted through on the drivers side. I started to make a patch with some sheet metal I bought a while ago and it's just too thick to make that many bends, damn it. I bought this 4x8 sheet of 18 gauge and I wish I hadn't, damn it. I wish one of you guys who need some thick stuff like this for a floor or something was closer so I could give some to you.
Anyway, I went and bought some thinner stuff to get this thing done. Brian
__________________
1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings" |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode