|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-10-2018, 05:07 PM
|
#1 |
|
Registered User
Join Date: Dec 2000
Location: Boise, Idaho
Posts: 6,003
|
How does the seat bolt into an AD?
It's been so long since I had a stock seat I don't remember. Does the seat simply bolt on top of the the mount that is welded into the cab? So if I were to section this mount lowering the top closer to the floor will the seat still simply bolt onto it?
In the second photo there are these two holes on each side of the rear of this seat mount. What are these holes for? I am thinking the gas tank straps? Thanks for all your info given. Brian
__________________
1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings" |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode