|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-24-2018, 02:12 PM
|
#1 |
|
Registered User
 
Join Date: Mar 2013
Location: Lenexa, KS
Posts: 547
|
RideTech Lower Cross Shaft Hole Alignment
So I am trying to button up the front suspension and came across a problem. The lower arms have 2 sets of holes. Instructions say to use the 9-1/2 center holes. While I was measuring, I checked to make sure they are centered on the shaft. Turns out they are not. They are 1/8” off set. The instructions do not mention anything about this. Any ideas? Figured this happens on a Sunday.
Thanks Nick Last edited by beaterku; 06-25-2018 at 10:46 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode