Grizz's Redneck Express 1966 Chevy Short Fleetside RESTO-GO!

[ibrown50]

Great progress Rian.

I have used paint stripper and a wire brush on a grinder to strip both my fenders, you're absolutely right you have to know what you are working with before you start any repairs. A blow torch and scraper removes filler very quickly,.

With your fender repair it's all down to personal choice, I wouldn't joggle the fender repairs, it does give you a bit of leeway if you get your cuts wrong but you will run into problems getting the wheel arch to look right and the seam at the door edge will be tricky too.

I'd always butt weld this kind of repair, if you take your time with the measurements, leave an 1/8" extra on the panel for wriggle room and then grind the last little bit until you have the perfect fit. You have the skills to do that no problem