Tranny crossmember - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**swervin ervin** · 05-15-2004, 01:16 PM

I'm trying to figure out what crossmember is best for what I want to do with my exhaust. I will be running 2.5" duals with two cats. I seen Ken's (N2TRUX) crossmember like in the first pic below. This looks good but is this a made crossmember or is there one like this somewhere on a vehicle. Personally, I've never seen one before.

Then there is the one like Jeff (bigblock73) has. This looks good but to me it puts the exhaust awfully close to the ground. I think I prefer to have one like Ken has so I can keep my exhaust up higher.

What does everyone think is best? And the bigger question, where can I find one of either of these?

05-15-2004, 01:16 PM	#1
swervin ervin You get what you pay for Join Date: Dec 1999 Location: Cherryville, NC Posts: 4,798	Tranny crossmember I'm trying to figure out what crossmember is best for what I want to do with my exhaust. I will be running 2.5" duals with two cats. I seen Ken's (N2TRUX) crossmember like in the first pic below. This looks good but is this a made crossmember or is there one like this somewhere on a vehicle. Personally, I've never seen one before. Then there is the one like Jeff (bigblock73) has. This looks good but to me it puts the exhaust awfully close to the ground. I think I prefer to have one like Ken has so I can keep my exhaust up higher. What does everyone think is best? And the bigger question, where can I find one of either of these? __________________ Mike 1985 Chevy C-10

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.