Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
10-26-2018, 10:35 AM | #1 |
Registered User
Join Date: Aug 2018
Location: Sunrise Beach, Missouri
Posts: 100
|
1966 Chevy C10 alignment?
I just got through replacing a drivers side lower control arm, new coils and shocks all around, lower ball joints and both sides tie rod assemblies. I installed all stock parts and didn’t lower the truck at all. I also replaced the panhard (trac) bar with an adjustable bar and have the rear end dead center now.
My question is what are the “toe” settings on this year truck? I have read 1/8th total IN....1/16th in on each side. I also saw different charts posted here that are totally different. I didn’t disrupt the upper camber settings at all. I was going to set my toe in or out using a string from back to front and measure the in-out on the front wheels so I can use the truck until I can get it in to the alignment shop. I’m involved with a project and need my truck to get lumber, plumbing and electrical supplies. This is my daily driver. Thank you for any replies. Greg |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|