|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-30-2018, 12:48 AM
|
#1 |
|
Active Member
 Join Date: Oct 2017
Location: Wappingers Falls, NY
Posts: 122
|
1969 Gas Filter Replacement
I want to replace the gas filter on the quadrajet carburetor, the issue that I'm having is that there is no room to fit my 1" open end wrench on the bolt due to the ports above and below the connection. If the wrench was "thin", it would probably work....was there a special wrench for this type of application ?
Thanks |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode