'72 C10 driveshaft, yoke, and universal. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Whamp48** · 01-11-2019, 08:18 PM

I have a '72 Cheyenne Super with BB, 400 trans, 12 bolt rear that the PO took apart and I'm slowly putting back together. Put the rear drive shaft in. There's no tabs in the yoke for the universal caps to go against. Matter of fact the universal is slightly wider than the yoke ears. It fits in the U, and seats all the way in. I haven't gotten to running it down the road yet, so I don't know about vibration. Did some of these trucks come out with an arrangement like I described?

01-11-2019, 08:18 PM	#1
Whamp48 Junior Member Join Date: Nov 2018 Location: Kirkwood, PA Posts: 98	'72 C10 driveshaft, yoke, and universal. I have a '72 Cheyenne Super with BB, 400 trans, 12 bolt rear that the PO took apart and I'm slowly putting back together. Put the rear drive shaft in. There's no tabs in the yoke for the universal caps to go against. Matter of fact the universal is slightly wider than the yoke ears. It fits in the U, and seats all the way in. I haven't gotten to running it down the road yet, so I don't know about vibration. Did some of these trucks come out with an arrangement like I described?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.