![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Nov 2018
Location: Flowery Branch, GA
Posts: 206
|
Stepside bed rear wiring routing?
(sorry, no pictures yet). On a '70 LWB stepside, how are the wires routed from the brake lights and back-up lights to the 4-pin frame connector? On both sides, there is a 2-pin connector to disconnect the brake lights, and a single pin connector to disconnect the back-up lights. The design of the 2-pin connectors make it look like they should snap into something, much like the 4-pin connector snaps into the frame.
I bought the truck as a partial restoration, and the harness was present, but not installed. This isn't a case of I took it apart and I forget how it goes back together ![]() Any pictures or good descriptions of how I should route and dress the wiring on her backend? Thanks, --jc
__________________
1970 C10 LWB Stepside 1971 Dodge Dart 1993 Buick Roadmaster Estate Wagon |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|