|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-22-2019, 12:40 PM
|
#1 |
|
Registered User
Join Date: Oct 2018
Location: Warsaw IN
Posts: 897
|
I made this for my bell housing.
I am running a hydraulic throwout bearing on my 53 1/2 ton. 292/Tremec TKO 600. I will have 2 hydraulic lines coming out of the hole where the clutch fork would normally go, supply and bleeder lines. I could not find anything that looks nice for this. This can be installed/removed from the outside. It's not perfect but I just used simple tools.
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode