|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-29-2019, 09:37 PM
|
#1 |
|
Registered User
Join Date: Sep 2013
Location: Gonzales, La
Posts: 1,441
|
Replaced power booster and MC. Pedal soft now
Well ol Samson got a new brake booster (stock) and master cylinder. Stock 4 drum brake system. Bench bled till no bubbles. Installed and hooked up lines. Bled from the farthest to the closest ran about 2 quarts through the system until clear fluid at each point.
Brake pedal still seems soft and sinks further to the floor than before. Way softer than before and goes almost to the floor before it stops. Also brakes don’t lock up like they use too. Old MC leaking out the back end seal and old booster leaking was the reason for replacement. Checked booster for leakage, nope. Checked vacuum, at 18hg, nope. Checked all bleeder points, no leakage, nope. Guess I’ll try to bleed the system again.........any ideas?
__________________
MyToys: Goldilocks the "Ol School Survivor" 1968 C10, SWB Stepside, 08/15 TOTM, 250 CI 6 cylinder, 3 on the tree, 3.73 rear, 3/5 static drop, 23,500 original miles. Samson the 1970 CST10, LWB, 462Ci, Turbo 350 tranny, 3.08 rear gear, PB, PS, A/C, AM/FM, 2/4 Drop. Brutus the 1998 Camaro Z28, 33,500 original miles, LS1, 519 RWHP/497 RWTQ. Member of the Louisiana Classic Truck Club, LCTC Member of the Louisiana C10 Club Member of the Baton Rouge Drifters Car Club |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode