Window division bar felt question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Fbks_Cruiser** · 05-03-2019, 11:08 PM

I recently purchased the 8 piece door window seal kit from GMC Pauls. Before I start pulling out my old seals I thought I should ask about my division bar. It appears to have some stainless trim along the edges. The one on the inside of the passenger door is damaged as you can see in the picture. Is this part of the felt and will just go away when I remove the old or is it actually part of the division bar? The new division bar felts I got do not have any stainless edging. Do I need it? If so can it be fixed without replacing the whole division bar?

05-03-2019, 11:08 PM	#1
Fbks_Cruiser Senior Member Join Date: Apr 2016 Location: Fairbanks, AK Posts: 343	Window division bar felt question I recently purchased the 8 piece door window seal kit from GMC Pauls. Before I start pulling out my old seals I thought I should ask about my division bar. It appears to have some stainless trim along the edges. The one on the inside of the passenger door is damaged as you can see in the picture. Is this part of the felt and will just go away when I remove the old or is it actually part of the division bar? The new division bar felts I got do not have any stainless edging. Do I need it? If so can it be fixed without replacing the whole division bar? Attached Images __________________ 1972 GMC K2500 Super Custom Matt

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.