Painless Wiring Harness - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Madbomber88 · 06-01-2004, 07:47 AM

I'm restoring a 71 K5 CST. I am basically replacing everything under the hood except the engine block. Right now I have the complete nose off, the alternator, water pump, valve covers, intake manifold, exhaust manifolds, etc... I also have a brand new wiring harness from Painless. At what point should I start putting it in? Is it easier to do now with everything off, or will it be better after everything is back in new?
Thanks in advance.
-Tim

06-01-2004, 07:47 AM	#1
Madbomber88 Active Member Join Date: Mar 2004 Location: Virginia Posts: 169	Painless Wiring Harness I'm restoring a 71 K5 CST. I am basically replacing everything under the hood except the engine block. Right now I have the complete nose off, the alternator, water pump, valve covers, intake manifold, exhaust manifolds, etc... I also have a brand new wiring harness from Painless. At what point should I start putting it in? Is it easier to do now with everything off, or will it be better after everything is back in new? Thanks in advance. -Tim __________________ 71 Blazer CST 72 K20 Capt USAF

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.