|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-13-2019, 06:47 AM
|
#21 |
|
Registered User
Join Date: May 2009
Location: Motor City
Posts: 9,294
|
Re: How did you get cab, box, burb, panel, blazer off the frame?
When I had the body off my Chevelle I did the railroad tie technique mentioned above with two floor jacks (one on each end of the railroad tie).
One other trick was to use bare steel wheels to roll the chassis in and out. Not only does it keep the whole affair lower but you can scoot it side to side when lining it back up to go together. K
__________________
Chevrolet Flint Assembly 1979-1986 GM Full Size Truck Engineering 1986 - 2019 Intro from an Old Assembly Guy: http://67-72chevytrucks.com/vboard/s...d.php?t=342926 My Pontiac story: http://forums.maxperformanceinc.com/...d.php?t=560524 Chevelle intro: http://www.superchevy.com/features/s...hevy-chevelle/ |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode