I am running 3/8 steel fuel line from my relocated rear tank, up to near my SBC where i would then like to go with a short piece of braided stainless line to connect into my mechanical fuel pump (which has a hose barb fitting as well)...
Question is, what fittings can i use to go from the steel hardline to a stainless flex line.. I was looking at something simple like the AN hose finisher clamps...would this be sufficient on both the stainless flex hose to hard line connection, as well as the braided hose to fuel pump?
https://www.amazon.com/dp/B07KLJSVKK...v_ov_lig_dp_it
09-18-2019, 10:03 AM
Threaded Mode