Need header help! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

n737nc · 06-11-2004, 10:15 AM

I just got a set of Dynomax headers from Jegs. Whent to bolt them up, no fit.

The drivers side is hitting the upper control arm.
The pass side is hitting the motor mount where it bolts to the frame. The pass side is about 1 inch from bolting up.

Anyone have this problem before?
Can you recoment a set of headers that will bolt up?

BTW-This is a 72 Chevy shortbed pickup, with a 350motor and 350 tranny.

Thanks,
Nick

06-11-2004, 10:15 AM	#1
n737nc Registered User Join Date: Jun 2004 Location: Dallas, Tx Posts: 207	Need header help! I just got a set of Dynomax headers from Jegs. Whent to bolt them up, no fit. The drivers side is hitting the upper control arm. The pass side is hitting the motor mount where it bolts to the frame. The pass side is about 1 inch from bolting up. Anyone have this problem before? Can you recoment a set of headers that will bolt up? BTW-This is a 72 Chevy shortbed pickup, with a 350motor and 350 tranny. Thanks, Nick

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.