Cab supports again... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

71c10longbed · 11-11-2019, 06:26 PM

On my 71 I am replacing the front cab support on the passenger side. My floor is still in place. On my drivers side I was able to cut out the rusty part and weld in patches. The passenger side is completely gone. I have removed a portion of it from the rocker back. I can't figure out how to get the rest out that is buy where the cab bushing nut goes through - between the floor and cab frame. I am using an air chisel but it only seems to be making noise. Any ideas?

11-11-2019, 06:26 PM	#1
71c10longbed Registered User Join Date: Dec 2015 Location: Denver North Carolina Posts: 28	Cab supports again... On my 71 I am replacing the front cab support on the passenger side. My floor is still in place. On my drivers side I was able to cut out the rusty part and weld in patches. The passenger side is completely gone. I have removed a portion of it from the rocker back. I can't figure out how to get the rest out that is buy where the cab bushing nut goes through - between the floor and cab frame. I am using an air chisel but it only seems to be making noise. Any ideas? Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.