TA_C10: Stage 1

[TA_C10]

Update - Finally Started Wiring!!

Been a long process doing all my research and putting together wiring diagrams and a plan, but today I started. I was able to modify the American Autowire main truck harness. I finished the inside cab bulkhead terminations. I removed a bunch of wires I didn't need and added LS stuff.

I have a bunch of other updates coming soon as well. Been working like crazy on this thing for a week or so. Stay tuned!

I removed the following:

Engine side:
TACH
Oil Sender
Water Temp Sender
VSS purple
VSS yellow
ECM Red

Front Light side:
Generator Lamp and Alternator Ignition

I added the following:
3 wire - OBDII
1 wire - TCC
3 wire - Cruise Control(TAC) - The 4th wire will be connected to rear tail light.
9 wire - TAC Module - Gas Pedal plug wires


Here you can see the newly added TCC, cruise control, and OBDII wires coming off the main trunk. None of these are internally fused. They were fused in the engine harness fuse block.







I filled the bulkhead up completely. To the right is my TAC module gas pedal plug(unfused) pinned up in bulkhead.





During the pinning process. Some of these I had to redo. The bulkhead requires the 630 series multi-pack terminals, female and male. All the pins were soldered after I crimped them.






And here are the wires I removed from the harness.