Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
02-26-2020, 02:51 PM | #1 |
Registered User
Join Date: Feb 2019
Location: Colts Neck, NJ
Posts: 14
|
3-speed saginaw behind a V8
I'm almost done putting back together my 67 c10 after a frame-off restoration. I'm planning on putting (at least for a little bit because I enjoy the 3ott) a rebuilt Saginaw 3-speed behind my new 383.
I understand this is kinda ridiculous, but I mostly bought the truck for the 3ott so I'd like to drive it for a bit this way and hope it doesn't just immediately crumble :-P My truck originally had an inline-6, which I swapped to this V8 moving the engine to the forward mounts as part of that. Now I need to get the transmission crossmember figured out since in it's original position it'll be back too far as I understand. These old transmissions had mounts on the bellhousing instead of at the tail. Since I need to remove and relocate the crossmember, I found this on ebay: https://www.ebay.com/itm/174157083393?ul_noapp=true and likely will pick it up since it should bolt exactly where I need it. My question is: Should I be aiming to use one of these bellhousing mounts, or is it preferable/possible to swap to a tail mount? Thank you as always! |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|