|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-19-2020, 11:39 PM
|
#1 |
|
Registered User
Join Date: Sep 2014
Location: Manley Hot Springs Alaska
Posts: 253
|
Reuse new head gasket and studs
I am wanting to torque a new head on to measure push rod length. Can I torque the head,do my measurements,then take the head back off to change out the light checker spring,then put the same gasket back on. Engine will not be run.
I also have head studs installed,only about 1K on them. Can I reuse these head studs. Same engine just new heads. Thank you. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode