New gauges came in, WHich one do I use ?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

RON WOODGEARD · 06-25-2004, 07:22 PM

If ya'll have been following the "behind the bezel installation of Autometer gauges, You know the 3-3/8" gauges have all been discontinued from the Autometer line..

I found two on ebay, New still in Bubble wrap. Bidded, and won them both..

Out of plain curiousity.. which would you put in the old tach opening. (the center hole between the fuel gauge and speedometer on our bezels) It's the one that needs the 3-3/8" gauge.

I think I'll go the Water Temp.

It changes the most the quickest in stop and go traffic..

and NO, I don't want to sell one, I want it for a back up..

View Poll Results: Which gauge to use for this purpose ??
Water Temperature	7	46.67%
Oil Pressure	4	26.67%
It doesn't matter just slap one in !!	4	26.67%
Voters: 15. You may not vote on this poll

06-25-2004, 07:22 PM	#1
RON WOODGEARD Resident Young Old Dude ! Join Date: Jul 2001 Location: Nevada Posts: 1,948	New gauges came in, WHich one do I use ?? If ya'll have been following the "behind the bezel installation of Autometer gauges, You know the 3-3/8" gauges have all been discontinued from the Autometer line.. I found two on ebay, New still in Bubble wrap. Bidded, and won them both.. Out of plain curiousity.. which would you put in the old tach opening. (the center hole between the fuel gauge and speedometer on our bezels) It's the one that needs the 3-3/8" gauge. I think I'll go the Water Temp. It changes the most the quickest in stop and go traffic.. and NO, I don't want to sell one, I want it for a back up..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.