Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-23-2020, 07:07 PM | #1 |
Registered User
Join Date: Jan 2004
Location: Whitehorse YK Canada
Posts: 2,651
|
Windshield w/trim question
I decided to replace the windshield rubber on my 68 C20 as it was old, hard and leaking.
I had swapped a windshield rubber on another and it went well, but it didn’t have the trim. So I read a bunch of threads in here to get hints, bought a Precision gasket, and watched the Precision YouTube video. Took a couple of try’s. Each time I did start pulling my rope from the top. Had a helper pushing from the outside. The rubber is not sitting right for about 12” on the right top corner. Everywhere else it looks good. There is a gap between the rubber and windshield. So is the trim not seated properly behind the glass? If so sny tricks to get that part in? I am wondering about having a helper press flat hands on the inside of the glass and then trying to tap the trim with my soft hammer? Or am I starting over?
__________________
Blaine 59 GMC 9314 a.k.a. Whoopee 68 C20 50th Anniversary a.k.a. The Rat http://www.flickr.com/photos/northerngmc/ http://www.members.tripod.com/P-wee/index_032.htm 1.61803 is one H of a lot better than 3.14159, no really it is! |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|