|
02-22-2021, 11:22 AM
|
#1 |
|
Senior Member
 
Join Date: Oct 2015
Location: Williamston, Mi
Posts: 885
|
Cast Headers
I have a new set of Langston cast iron headers I'm going to install on my 292. I'm thinking I would like to have them powder coated. If I do this will this last or will it slowly burn off? I'm sure a few have probably done this so I'n just looking for any advise. Also does anyone have a ball park figure on approximately how much this should cost to have done? Never had anything powder coated so this is a new experience.
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode