|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-20-2021, 03:55 PM
|
#1 |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,599
|
Removing pitman arm from center link
I'm having one heck of a time trying to remove the pitman arm from the center link on my 69 C10. Closest size puller I have doesn't grab enough iron to work. Pickle fork doesn't do any good and I'm afraid it will mess up the rubber.
I've done it twice before on this truck and don't remember having problems. I'm thinking my next step will be holding a body dolly on one side and smacking the other side with a sledge hammer. Any other ideas?
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, recent AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode