![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#11 |
Senior Member
![]() Join Date: Mar 2012
Location: Kansas City, MO
Posts: 2,011
|
Re: 57 Chevy Wagon - Californa Dreamin'
Over the last couple of weeks we attended a few car shows / cruise-in's and I've had enough for the season. I'm ready to get on with the repairs the old gal needs. First up is to remove the radiator, ac condenser, fans, shroud and wiring. Then off comes the intake, carbs, regulator and etc. After that, I'll remove the front seats and console. Last of all, the exhaust pipes back to the mufflers, the driveshaft, the rest of the wiring and nearly all the hardware holding the transmission.
Once I get to that point, I'll have Hot Rod Express haul it to their shop and yank the tranny the rest of the way out. It goes to Nicholls Performance Transmission to have the internals swapped into a different (un-cracked) case. They will also inspect and repair anything they might find. They will also source a different converter for it that doesn't flash to 3000 rpm every time you tip in the throttle a little bit. Meanwhile back at the ranch, I've been preparing for the switch back to EFI. All that will remain of my original setup is the sheet metal intake. It has a new (correct) Nick Williams throttle body, new FIC 60lb injectors and a new Holley Terminator X ECU and harness. I've been building a calibration file based on my sensors and other engine components. I'll write it to the ECU when I get everything assembled and see if it will start. It has a self learning feature, so I hope to be able to get it running well enough to make it to the tuner down in Belton if need be. I'm keeping the Painless trans controller which I hope isn't a bad decision, but I've been tweaking it some recently and it's made a lot of difference in the way the tranny performs. I'll probably have to start over with the new converter, but I have a route I run to test my changes with convenient places to stop and make adjustments on the fly. So the radiator is getting pumped out today in preparation for removal. It will probably look a bit sad over the next couple of months but it will be worth it.
__________________
Victor 57 Chevy Wagon - California Dreamin'"Mecum'd" 9/2022 Dallas, TX Crusty Rusty Leaky Squeaky 67 Consigned 4/2019 Dresden, Germany Maybelline - my '57 Ford 2dr Sedan "Mecum'd" 3/2016 Location unknown Silver Streaker "Mecum'd" 4/2013 Somewhere in Texas |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|