Okie, two questions about replacement trannies! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Patrick Sullivan · 06-10-2002, 11:49 PM

OK, after calling around to the different tranny shops in town and in Portland, I have come to the stunning conclusion that it would actually be cheaper to pick up an aftermarket tranny and put it in then have someone rebuild my current one. So:

1) I'm looking at two companies, TCI and B&M - anyone had any good/bad experience with either? Any other aftermarket tranny companies that people have had good luck with?

2) From where to where on my TH-350 do I measure to determine if I have the 4", 6" or 9" tailshaft? Also, how do I know if I have the "standard diameter yoke" or not?

Thanks..

06-10-2002, 11:49 PM	#1
Patrick Sullivan Transcendental Trucker Join Date: Dec 2001 Location: Rockaway Beach, OR Posts: 374	Okie, two questions about replacement trannies! OK, after calling around to the different tranny shops in town and in Portland, I have come to the stunning conclusion that it would actually be cheaper to pick up an aftermarket tranny and put it in then have someone rebuild my current one. So: 1) I'm looking at two companies, TCI and B&M - anyone had any good/bad experience with either? Any other aftermarket tranny companies that people have had good luck with? 2) From where to where on my TH-350 do I measure to determine if I have the 4", 6" or 9" tailshaft? Also, how do I know if I have the "standard diameter yoke" or not? Thanks.. __________________ Patrick Sullivan \| sullivan@oregoncoast.com Rockaway Beach, Oregon 1972 Chevy Cheyenne C-20 1998 Dodge Dakota 4x4 So, fill to me the parting glass And drink a health whate'er befalls... Then gently rise and softly call Goodnight and joy be to you all!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.