02-05-2022, 07:34 PM | #11 |
Registered User
Join Date: Nov 2010
Location: calgary alberta
Posts: 7,926
|
Re: 1950 Build
one little tidbit, maybe you use it or maybe not thats up to you, when levelling the cross member use the lower control arm pivot bolts installed into their bores but leave enough sticking out so a long level can be placed across them side to side. that is better than assuming they are in line with the outside formed metal of the cross member. same for the fore to aft levelling, use a shorter level on the pivot bolt and have it sticking out enough to allow the level to sit on the shaft of the pivoy bolt. my cross member was not really flat on top and also was not completely true to the pivot centerline.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|