Removing rear axle dust shield '66 C20 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Railroadman · 02-15-2022, 11:09 PM

EDIT - Got it, heat gun and a lot of tapping did the trick.

What's the method of removing the dust shield on the rear of my '66 3/4 ton? If I ever knew, it's been too many years of playing with discs. I want to pull the backing plate off and blast it.

(Secondary question - I have the shop manual, but don't see it there. Does anybody else wish the darn book didn't cover everything up to dump-truck sizes? A nice 1/2 and 3/4 ton only would be nice but I'll take what I can get.)

02-15-2022, 11:09 PM	#1
Railroadman Registered User Join Date: Jun 2016 Location: Rochester NY Posts: 117	Removing rear axle dust shield '66 C20 EDIT - Got it, heat gun and a lot of tapping did the trick. What's the method of removing the dust shield on the rear of my '66 3/4 ton? If I ever knew, it's been too many years of playing with discs. I want to pull the backing plate off and blast it. (Secondary question - I have the shop manual, but don't see it there. Does anybody else wish the darn book didn't cover everything up to dump-truck sizes? A nice 1/2 and 3/4 ton only would be nice but I'll take what I can get.) Attached Images Last edited by Railroadman; 02-16-2022 at 11:42 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.