Upper control arm washers - The 1947 - Present Chevrolet & GMC Truck Message Board Network

DLH · 06-15-2022, 04:57 PM

1982 ½ ton C10
I am upgrading my 70 c10 to power steering using a 1982 doner. Ran into a problem on my suspension rebuild, 2 leftover washers in my bucket (small ones in the pic).

I figured out where they go. 1 washer per upper control arm next to the rear bushing. Circled in red in the pic. The picture is a lot better on my computer, I can see them clearly. It bugs me I left them out, but they don’t appear to be needed. I can’t find them in the catalogs. I have not found a thread here of anybody using them in their rebuild, no you tube videos either. So……..can I leave them out?

06-15-2022, 04:57 PM	#1
DLH Registered User Join Date: Feb 2022 Location: CENTRAL OKLAHOMA Posts: 23	Upper control arm washers 1982 ½ ton C10 I am upgrading my 70 c10 to power steering using a 1982 doner. Ran into a problem on my suspension rebuild, 2 leftover washers in my bucket (small ones in the pic). I figured out where they go. 1 washer per upper control arm next to the rear bushing. Circled in red in the pic. The picture is a lot better on my computer, I can see them clearly. It bugs me I left them out, but they don’t appear to be needed. I can’t find them in the catalogs. I have not found a thread here of anybody using them in their rebuild, no you tube videos either. So……..can I leave them out? __________________ David

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.