Dana 60 Axle Shaft lengths - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Eagle Kammback · 07-13-2023, 07:28 AM

Well, snapped an axle in my 72 C25, and I have to get her back up and running ASAP (she's my daily)
But I can't find any sources to tell me the shaft lengths. I figured the shafts are probably different lengths, so I can't just use my good one to get them cut down.
I'm gonna be doing both sides so I don't have to worry about it again.
It also seems that the only company making 30 spline axles for this is Yukon.
Sorry if this is a bit scatterbrained, I'm just having a rough time after BOTH my vehicles were rendered inoperable within a month haha

07-13-2023, 07:28 AM	#1
Eagle Kammback Registered User Join Date: Jan 2017 Location: Indianapolis Posts: 25	Dana 60 Axle Shaft lengths Well, snapped an axle in my 72 C25, and I have to get her back up and running ASAP (she's my daily) But I can't find any sources to tell me the shaft lengths. I figured the shafts are probably different lengths, so I can't just use my good one to get them cut down. I'm gonna be doing both sides so I don't have to worry about it again. It also seems that the only company making 30 spline axles for this is Yukon. Sorry if this is a bit scatterbrained, I'm just having a rough time after BOTH my vehicles were rendered inoperable within a month haha Attached Images __________________ 1972 GMC C25 350 Muncie 465 - Daily Driver 1979 AMC AMX 304 4 Speed -Mechanic Special 1983 AMC Eagle - The Eternal Project

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.