![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#4 |
Registered User
Join Date: Nov 2010
Location: calgary alberta
Posts: 8,026
|
Re: 52 step side frame swap.
you probably should get some actual dimensions from your truck so you have something to compare with. you may also need to figure out what you want the truck to be when it is all grown up. a truck that has a set of huge width rear tires will likely need a whole new rear frame section that is narrowed to allow that. in that case you need to look for a donor frame that has what you want for front suspension etc. if you want to stick with something more normal in the tire width area so it is more of a daily driver and comfort is more appealing than being an inch off the ground then that also changes the range of what is available for donors. if you plan to modify the suspension then finding something that has a good aftermarket following for parts is kinda important. that is why the S10 has been used for a lot of frame swaps on the AD trucks, lots of aftermarket support for air bag suspension, lowering parts, different control arm lengths, etc etc. joedoh, a member here, sells a mount kit for the S10 frame swap and if interested a private message to him could answer a lot of questions.
dimensions you might wanna know before looking for a donor width from inside the rolled fender lips front and rear desired tire width and outside diameter when truck is done. makes a difference, especially on the front axle, when it comes time to turn the steering. otherwise the tires rub the fenders amount of dish you want in the wheels when all done (makes a difference for width of axles from wheel mounting flange to wheel mounting flange) frame width, not that this is a big deal because you will be fabbing up new body mounts anyway |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|