Headlight and wiper dash hole alignment with gauge bezel

[siggyfreud]

Hey all,

I'm currently working on a project for a custom dash bezel. I have made my bezel mount and headlight/wiper hole locations exactly as the stock bezel I have, however, I've noticed that the headlight and wiper holes in the dash sheet metal are not exactly aligned dead center with the stock bezel in place. The sheet metal holes are slightly further out and maybe a tad higher when looking at them straight-on.

I'm curious if this is common/regular on other trucks, or if mine is slightly askew.

Basically, when making this new bezel I'm trying to determine if there would be a detriment centering them better than my factory appeared to be.

Cheers!