Shaved drip rails, frenched antenna & smoothed firewall pictures - The 1947 - Present Chevrolet & GMC Truck Message Board Network

68LSS1 · 12-01-2004, 01:43 AM

Here are a few pictures I got today. Quality sucks as the sun was going down when I took them. Also link my in sig now works again and I will add more pictures in the very near future. There are acouple of the HTH and Fatman Fab there now.

Ed @ Mothertruckers is responsible for the metal work on the cab. I had the cab dipped prior to the metal work (actually Ed took care of that also). I call it a smoothed firewall because in my opinion it's not shaved. Close on the passenger side. Trying to get the motor mounts/tranny cross member fabbed and then off to the welding shop for the roll cage.

12-01-2004, 01:43 AM	#1
68LSS1 Registered User Join Date: Dec 2002 Location: Tampa Posts: 1,191	Shaved drip rails, frenched antenna & smoothed firewall pictures Here are a few pictures I got today. Quality sucks as the sun was going down when I took them. Also link my in sig now works again and I will add more pictures in the very near future. There are acouple of the HTH and Fatman Fab there now. Ed @ Mothertruckers is responsible for the metal work on the cab. I had the cab dipped prior to the metal work (actually Ed took care of that also). I call it a smoothed firewall because in my opinion it's not shaved. Close on the passenger side. Trying to get the motor mounts/tranny cross member fabbed and then off to the welding shop for the roll cage. __________________ '68 Short Step LS1/T56, Hydratech, Fatman Fabrications Stage III, Baer, Hot Rods to Hell, US Body, S&W, etc Last edited by 68LSS1; 12-01-2004 at 01:55 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.