Hello ; New member

[Bondoman]

Hello everyone, I am glad i found this board there is alot of helpfull info here. I just bought a 68 chevy C10 short/step bed 350 auto, after a couple years of looking. I would like to run a few questions by everyone.

1. I have searched back posts and it appears to convert to power steering all i need is gearbox, rag joint and pitman arm from 79 or below, Right?

2. Same for power brakes. Plan to leave drum brakes on for now?

3. Steering column, are there any other columns that will fit close. looking for a newer column with tilt and ignition on column?

4. I have disassembled the truck starting to strip now. I am priming with spray cans as i go. question is when i am ready for final primer coats I will remove the can primer then what should i do to bare metal? ?Use some of the rust stuff or viniger or just reprime with a good primer?

Thanks for any help