Pulling distributor - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Yukon Jack** · 07-02-2002, 05:06 PM

I'm considering pulling the old distributor and replacing it with an HEI unit. My spark plug wires are chewed up by rats and it's time to replace them anyway.

When I was looking at my engine this morning it doesn't look like the distributor could be pulled up and out without hitting the firewall above the distributor. My engine is a 307 and it is in my 4x4.

This pic doesn't show the potential problem too well, but maybe you can see the problem.

Anyone have a similar problem? If so, what was your solution?

07-02-2002, 05:06 PM	#1
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,686	Pulling distributor I'm considering pulling the old distributor and replacing it with an HEI unit. My spark plug wires are chewed up by rats and it's time to replace them anyway. When I was looking at my engine this morning it doesn't look like the distributor could be pulled up and out without hitting the firewall above the distributor. My engine is a 307 and it is in my 4x4. This pic doesn't show the potential problem too well, but maybe you can see the problem. Anyone have a similar problem? If so, what was your solution? __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.