axle swap

[crosby]

I have an 87 K20, and an 85 K30 single rear wheel. I'd like to pull the axles, tranny and transfer case out of the one ton, and stick them in the 3/4. Does anyone know if these axles will bolt up to the 3/4, or does this require modification. Can I/should I use the one ton springs? Will the steering setup be any different? I would also like to swap in the Hydroboost setup, which I am sure will be a nightmare, but will be worth it in the long run. Eventually I plan on installing lifted springs, so that might be a factor in the swap. Right now, the truck is a lawn ornament, that should be plowing my driveway... I am putting a 350 in it over the next couple of months, and want to strip and scrap the one ton ASAP. Thanks very much for any help!!
HAPPY NEW YEARS!!