72 C20 wheel stud length - The 1947 - Present Chevrolet & GMC Truck Message Board Network

WB72 · 07-10-2002, 03:58 PM

I would like to put 2001 center caps on my ralley wheels. The problem is that the center caps thread on to the lug nuts of the wheels. And of course, the nuts don't interchange but they are close.

If I get new studs and nuts, (I believe that they are either a bit larger or have a different thread pattern). Will I be able to just press (hammer) the old ones out and the new ones in ?

Without taking them out, I'm not sure of the length for the disks up front and the drums out back. Are they the same length?

07-10-2002, 03:58 PM	#1
WB72 Before and After Join Date: Feb 2000 Location: Leduc, Alberta CANADA Posts: 632	72 C20 wheel stud length I would like to put 2001 center caps on my ralley wheels. The problem is that the center caps thread on to the lug nuts of the wheels. And of course, the nuts don't interchange but they are close. If I get new studs and nuts, (I believe that they are either a bit larger or have a different thread pattern). Will I be able to just press (hammer) the old ones out and the new ones in ? Without taking them out, I'm not sure of the length for the disks up front and the drums out back. Are they the same length? __________________ Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.